THIS POST IS FOR FITNESS EQUIPMENT THAT HAS BUILT-IN WIFI AND AN LCD DISPLAY (NON-TOUCHSCREEN), BUT DOES NOT REQUIRE A MODULE.
Please scroll to the bottom, download the file for your particular equipment type (treadmill, bike, or elliptical), then continue with the instructions below.
Next, to connect your equipment to WiFi, follow these steps by referring to the PDF file:
- Enter Settings Mode and navigate the menu. (Steps 1–2)
- Clear your WiFi settings. (Step 3)
- Set up a WiFi connection using WiFi-Normal. (Step 4)
- Lastly, go to iFit.com/connect, then enter the 5-digit code. (end of Step 4) This will allow you to use iFit on your equipment.
NOTE: The 5-digit code is only good for a few minutes, so it will work best if you are already logged in to your iFit account on a separate device (phone, tablet, or computer) before you start the process.
Once your equipment is connected to WiFi, the WiFi icon on your display will stop flashing and become solid. Four arcs indicate full signal strength.
If you continue to have issues connecting, check your router settings to make sure they are compatible with your fitness equipment. In some cases, you may need to reset your equipment to the factory settings.
MAC Address Filtering: Disabled
Broadcast in 802.11 B/G/N
Guest networks are not compatible.
Satellite-based internet may have issues.
Passwords cannot contain any special characters. Only numbers and/or letters.
Passwords that are more than 13 characters in length can cause connection issues.